‘Gas-on-glass’ hobs - How to replace the burner cover

Решење

Refer always to your product’s user manual safety information before any repair or maintenance operation. https://www.electrolux.com/support/user-manuals/

WARNING! RISK OF ELECTRIC SHOCK

Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.

WARNING! RISK OF INJURY

Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.

WARNING! RISK OF EYE INJURY

Wear safety glasses if you perform maintenance or repair work involving springs.

WARNING! RISK OF BURNS

Before any repair or maintenance operation make sure the appliance is not hot.

WARNING! CHOKING HAZARD

Small parts not for children under 3 years. Keep all small parts and packaging out of reach of children.

Only adults should use or install the product.

Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.

Do not use or install the product if damaged.

Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.

HOW TO REPLACE THE BURNER COVERS

In most of the appliances ‘Gas-on-glass’ hobs, the burner covers are glued with silicone to the hob glass. To mount new ones, it is required to additionally order gaskets according to spare part list to replace silicone. Since some models don’t use gaskets it’s necessary to order the tube of silicone with spare part number 4071354783 to replace the burner cover.

1. Unscrew the screws holding old cover to hob

2. Remove the old cover using a tool with rounded edge not to scratch the glass surface.

3. Remove remaining silicone from glass surface.

4. Clean glass surface from silicone residue.

5. Replace the old cover by the new one using gasket according to spare part list for proper type of burner (if gasket not applicable for the appliance, move to step 5 with silicone assembly).

6. Mount cover using the same screws and fix it tightly.

Replacement of burner cover with silicone spare part

From step 5 since all previous steps are the same:

5. Apply only one silicone ring on glass border.

6. Install new cover based on screw holes position located on gas burner to allow the cover fixation in the right position.

7. Use a cloth wet of acetone in case of necessity to remove excess of silicone.

8. Do not use hob for approximately 1 day to allow silicone to dry out.